6100-Gfast Multifunction Network Analyzer Operation Manual
114
© 2020 Radiodetection Ltd
3. Press
on a value to open a list box of
options.
4. Press
to confirm the value.
Sweep Threshold Settings
The
Return Loss Sweep Threshold Settings
page is
similar to the
Single Frequency
test and allows you to
set the
Loss Threshold
for each pair.
In addition, you can select
Mask
as a threshold and
view the
Mask Tolerance
. The threshold is a
programmable value you can use as an on-screen
indicator in each test when a measured value is too
high or too low.
Type
is the threshold limit for each pair.
Selecting
Minimum
or
Maximum
acts as the
single point
P/F
threshold
flat
mask while
selecting
Mask
provides a
shaped
mask as
threshold. When
Mask
is selected, it will be
used as pass/fail criteria next time the test is
run, and
Loss Threshold
becomes read-only.
Enabled
is a flag to use the
Return Loss
threshold: either
Yes
or
No
. For example,
setting the threshold
Enabled
to
No
will disable
pass/fail threshold.
Mask Tolerance
is a fixed value representing
a marginal pass area on the graph shown in
yellow.
To set threshold values:
1. Press the up/down arrow keys to highlight the
desired parameter.
2. Press the left/right arrow keys to view and
select the options.
OR
3. Press
on a value to open a list box of
options or the alphanumeric editor screen and
use the navigation keys to scroll through.
4. Press
to confirm the value.
Sweep Result Details
The
Sweep Result Details
read-only page displays the
pass/fail status and test results in graphical format.
Test Group
is the overall test group of the
selected saved results file, for example
Frequency Tests
.
Test Identification
is the test type of the
group, for example
Return Loss
.
Test Modes
is the mode of test, for example
Sweep
.
Select Graph
button opens a new selection of
function keys which allow you to maneuver the
graph as follows:
o
Cursor
- press the left/right arrow keys
to decrease/increase the values by
moving the cursor. Press and hold the
left/right arrow keys to accelerate the
cursor. Press
to recall the cursor
