Rabe Super Albatros 140 RMW+, Руководство по эксплуатации

Страница: 3 / 118

- 3 -
B
RIEF INSTRUCTIONS
S
UPER
A
LBATROS
140 MW; S
ERIES
2
9901.00.34DE00; 02.2017 6XEMHFWWRWHFKQLFDOPRGL¿FDWLRQV
Quick guide for experienced operators, always observe the detailed operating
instructions as well.
BRIEF INSTRUCTIONS
1 P
REPARING THE TRACTOR
Ź
Calculate required ballast for the tractor, then
attach ballast.
Ź Check that the air pressure in the tractor's tyres
is correct and equal.
Ź
Check the output and lifting capacity of the rear
power lift on the tractor in relation to the plough
version.
Ź Check the permissible axle load for the tractor.
Ź
Check that tractor’s and implement’s
connection categories are the same.
Ź
Set the bottom links to the same height.
Ź
Limit the bottom links to a low lateral ...
... tolerance with the side locks when raised
and adjust them so that they ...
... move freely when lowered.
Ź
Set the tractor hydraulics to traction control.
Ź
Check the bottom link’s lifting height.
Minimum lifting height = 85 cm
BRIEF INSTRUCTIONS
TABLE OF CONTENTS FOR THE BRIEF INSTRUCTIONS
1 Preparing the tractor ......................................................... 3
2 Coupling the implement .................................................... 4
3 Folding up the parking support ........................................ 5
4 Moving the plough into the transport position ............... 5
4.1 Turning the plough onto the right-hand side .............. 5
4.2 Turning the combination wheel into the transport
position ...................................................................... 6
4.3 Lifting the ploughs with depth guide wheel into the
transport position ....................................................... 7
5 Travelling by road .............................................................. 7
6 Moving the plough with combination wheel into the
working position ................................................................ 8
7 Moving the plough with depth control wheel into the
working position ................................................................ 9
8 Removing the lighting ....................................................... 9
9 Working values: Working speed / working depth ........... 9
10 Adjusting the traction point ............................................ 10
10.1 Plough with turnbuckle ............................................ 10
10.2 Plough with hydraulic frame slewing ....................... 10
11
$GMXVWLQJWKH¿UVWERG\ZRUNLQJZLGWK
......................... 11
11.1 Plough with adjusting spindle .................................. 11
11.2 Ploughs with hydraulic cylinder ............................... 11
12 Adjusting the working depth .......................................... 12
12.1 Preparation .............................................................. 12
12.2 Depth adjustment, depth control wheel PS 5 .......... 12
12.3 Depth adjustment, depth control wheel PS 30
and combination wheel D 30 ................................... 12
12.4 Depth adjustment, RJR wheel ................................. 13
13 Aligning the plough parallel to the ground ................... 13
14 Adjusting the incline ....................................................... 14
15 Installing the lighting ...................................................... 14
16 Adjusting the working width ........................................... 15
17 Adjusting the track of the contact or combination
wheel ................................................................................. 15