Pavone Systems MCT 1302, Техническое руководство, Страница: 24 / 84

Page 22
RECIPE BATCHING SELECTION
Press on the recipe dial, in the instrument main screen, to access the active recipe selection screen.
The available recipes are displayed, divided into
pages of 4 elements. Press on the recipe line you
want to activate. To quickly select an item in the
archive, hold down the page change key for a long
time, and the recipe index setting screen will be
displayed. After setting the index, the page where
the required element is present is automatically
displayed.
The recipes can also be selected via inputs.
PROGRAMMING THE RECIPE CYCLE NUMBER
From the general screen, it is possible to access the programming of the number of cycles that will be
automatically executed following a START batching.
• The number of cycles can be set from 1 to 99; by setting the value 99, the batching cycle is repeated
indefinitely until the manual stop by the operator.
• At the end of the programmed cycle sequence, the value of this parameter is automatically reset to 1.
RECIPE CORRECTION FACTOR PROGRAMMING
From the general screen, it is possible to access the recipe correction factor programming.
According to the “Correction Mode” parameter in the “Batching Parameters” menu, the correction
factor is managed in the following ways:
• FACTOR - The correction of the recipe is performed by entering a multiplying factor of the setpoints.
Parameter programmable from 0.01 to 10.00, which allows you to reduce up to one cent or multiply
up to ten times the total weight of the recipe.
• WEIGHT - The correction of the recipe is performed by entering the total weight value that you
wish to dose, so the recipe setpoints will be automatically recalculated to obtain the desired total.
Changing the correction value creates the printout of the recipe with the recalculated batching set point,
if the “PRINT DOS” parameter is “ON”.
J
J
J