Parker Dynaserv G2, Руководство пользователя

Страница: 53 / 189

4-18
Basic Settings for Operating the Motor
4
4.8 Performing the Basic Settings of Pulse Commands
4.8.1 About Position Command Pulse Input
Perform input (pulses) required for operation according to the explanation in Section 6.2, “Position Command
Pulse Input” in Chapter 6, “Controller Interface.” Prior to performing pulse input, be sure to perform required
settings according to the explanation in Section 6.1, “Terminal Function.”
The position command value instructed from the controller interface is given to the driver by any pair of the
(PLS, SIGN), (UP, DOWN) and (A, B) signals, which is then reflected in the command unit command value.
Which pair of the signals will be used to give a command is set with the
#204 Command pulse type
parameter.
+ direction - direction + direction - direction + direction - direction
(PLS, SIGN) (UP, DOWN) (A, B)
SIGN
PLS
PUA_IN
±
SDB_IN
±
UP
The signal should be H when active
(status for flowing current to the
driver photocoupler).
As for the PLS, it should be L when
normal.
DOWN
A
B
Caution
3
µ
s min 3
µ
s min
150ns min
The signal should be H when active
(status for flowing current to the
driver photocoupler).
As for both the UP and DOWN, they
should be L when normal.
150ns min
6
µ
s min
The signal should be H when active
(status for flowing current to the
driver photocoupler).
300ns min
The position command value instructed from the controller interface can change the weight of a single pulse on
the interface by the input signal “PLS_DIRECT.” When the status of the input signal “PLS_DIRECT” is 0, a
single pulse on the interface becomes the value set with the
#207 Simplified scaling weighted data
parameter.
While the status of the input signal “PLS_DIRECT” is 1, a single pulse on the interface is independent of the
value set with the
#207 Simplified scaling weighted data parameter, and becomes a single pulse inside the
driver.
However, do not change the status of any of the (PLS, SIGN), (UP, DOWN) and (A, B) signals for 2 msec each
before and after switching the input signal “PLS_DIRECT” (off
→
on, on
→
off).
PLS_DIRECT
PUA_IN
±
Unchanged
Status 1
Status 0
SDB_IN
±
2 msec
or more
2 msec
or more
2 msec
or more
2 msec
or more
Unchanged
Unchanged
Unchanged