Parker Dynaserv G2, Руководство пользователя

Страница: 166 / 189

204 Command pulse type While in machine setting mode
Minimum value:
0
Maximum value: 2
Initial value: 2
Unit:
None
Long:
Short:
CmdPlsType
CmdPlsType
Specify the position command pulse type.
0: PUA_IN:UP, SDB_IN:DOWN
1: PUA_IN:A, SDB_IN:B
2: PUA_IN:PLS, SDB_IN:SIGN
205 Monitor pulse type While in machine setting mode
Minimum value: 0
Maximum value: 1
Initial value: 1
Unit: None
Long:
Short:
MonPlsType
MonPlsType
Specify the position monitor command pulse type.
0: UA_OUT:UP, DB_OUT:DOWN
1: UA_OUT:A, DB_OUT:B
206 Enabling current limit external input While in machine setting mode
Minimum value: 0
Maximum value: 1
Initial value: 0
Unit:
None
Long:
Short:
ExtCurLmtEn
ExCurLmtEn
Specify whether or not to perform a current limit according to the current limit external input signal.
0: Do not perform.
1: Perform.
207 Simplified scaling weighted data While in machine setting mode
Minimum value: 1
Maximum value:
64
Initial value: 4
Unit: None
Long:
Short:
CmdWeight
CmdWeight
Specify how many pulses a single command unit equals to during a simplified scaling operation. Specify in a power of
2 (e.g., 1, 2, 4, 8, …).
213 Axis maximum velocity While in machine setting mode
Minimum value: 1
Maximum value: 16000000
Initial value: Motor dependent
Unit: Axis command unit/sec
Long:
Short:
Vmax
Vmax
Specify the maximum velocity during operation. The actual maximum velocity is determined by the smaller value of
this parameter or the maximum velocity [axis command unit/sec] converted from the maximum velocity [rps, mps]
determined by the motor and driver. This maximum velocity value is displayed on the monitor.
218 Enables error when over-load occurs While in machine setting mode
Minimum value: 0
Maximum value: 1
Initial value: 1
Unit:
None
Long:
Short:
OverloadErrorEn
OVL_ErrEn
Specify whether or not to process as an error when over-load occurs.
0: Does not process as an error.
1: Processes as an error.