8 – 69
Aquarea air/water heat pump – Installation manual for monobloc and split systems C, D and E series 05 / 2014
8
Electrical
ins
tallation
Electrical installation
Installing the wired remote control
Laying visible cables
8.4.2 Laying visible cables
1
Remote control cable
2
Upper clamp
3
Upper cover
4
Plug connector (CON1)
5
Lower cover
6
Screw
7
Lower clamp
1
Cable outlet to the top
2
Lower cover
3
Tabs
4
Remote control cable
5
Notches
1
5
4
3
2
Laying visible cables
1
3
4
5
6
7
2
Danger!
Lay the cable as shown in
the figure above so that the
housing of the remote control
can be closed securely .
➤
Use the two supplied M4 × 14 screws to secure the lower cover of the
remote control to the wall . When tightening the screws, ensure that
the screw heads not sitting proud . Use only the supplied screws .
➤
Select an outlet direction of your choice for the remote control cable
and use a wire cutter to open one of the notches provided for this pur-
pose in the upper cover in accordance with the outlet direction .
➤
Route the remote control cable in the lower cover as shown in the
figure based on the outlet direction selected .
➤
Fasten the connection of the remote control cable to the plug
connector (CON1) in the upper cover of the circuit board . Ensure
that is securely attached .
➤
Secure the cover to the lower cover of the remote control using the
clamps provided .
