8 – 68
Aquarea air/water heat pump – Installation manual for monobloc and split systems C, D and E series 05 / 2014
Electrical installation
Installing the wired remote control
Laying concealed cables
You can lay the wired remote control cable so that it is concealed
or visible:
1
2
8
7
3
4
5
6
1
Upper cover
2
Upper clamp
3
Plug connector (CON1)
4
Lower cover
5
Screw
6
Lower clamp
7
Flush-mounted box
8
Remote control cable
1
Upper cover
2
Cable outlet to the rear
3
Lower cover
4
Tabs
5
Upper cover
6
Cable connection (CON1)
5
4
3
6
1
2
Laying cables in
the wired remote
control
Laying concealed cables
8.4.1 Laying concealed cables
➤
Insert a flush-mounted box (to be provided by the customer) into the
wall (medium-sized rectangular socket,
Panasonic part no . DS3744
or similar) .
➤
Insert the wired remote control cable into the socket .
➤
Route the concealed wired remote control cable to the wired remote
control as shown in the figure .
➤
Use the two supplied M4 × 30 screws
to fasten the lower cover of the remote control to the flush-mounted
socket . Ensure that the lower cover is not under strain and do not
tighten the screws excessively . Use only the supplied screws .
➤
Fasten the connection of the remote control cable to the plug
connector (CON1) in the upper cover of the circuit board . Ensure
that is securely attached .
➤
Secure the upper cover to the lower cover of the remote control using
the clamps provided .
Danger!
Lay the cable as shown in
the figure above so that the
housing of the wired remote
control can be closed securely .
Warning!
In cavity walls, use a bushing
for the wired remote control
cable to prevent rodents biting
the wire .
Warning!
If plugs are removed during in-
stallation, the wiring is twisted
on 2 and 3:
