Panasonic AFP7MC16EC, Руководство пользователя

Страница: 394 / 504

Troubleshooting
15-30
● :
Recoverable, -: Unrecoverable
Warning
code
Warning name Description Object Recovered Countermeasures
0070H
Movement amount
change function
disable warning
(except positioning)
The movement amount
change request contact
turned on when the
positioning operation was
not performed.
Each
axis

Check the timing that the
movement amount change
request contact turns on.
0071H
Movement amount
change function
disable warning
(interpolation
operation active)
The movement amount
change request contact
turned on during the
interpolation operation.
Each
axis

0072H
Movement amount
change function
disable warning (J-
point control active) The movement amount
change request turned on
during the J-point
operation.
Each
axis

0073H
Movement amount
change function
disable warning
(Synchronous slave
axis specified)
The movement amount
change request contact
of synchronous slave axis
turned on.
Each
axis

0074H
Movement amount
change function
disable warning
(Positioning done)
The movement amount
change request contact
turned on in the state that
the positioning output is
complete.
Each
axis

0075H
Movement amount
change function
disable warning
(During positioning
stop process) The movement amount
change request contact
turned on when any
positioning stop
processing is performed.
Each
axis

0076H
Movement amount
change function
disable warning
(During dwell process)
The movement amount
change request contact
turned on when the
positioning dwell
processing is performed.
Each
axis

0100H
Synchronous setting
change disable
warning
The change of the
synchronous setting was
requested on an
operating axis.
Each
axis

Changing the synchronous
setting should be performed when
the busy flag for the axes to be
synchronized is off.
0110H
Cam pattern table
reading warning
The operation for the cam
pattern table reading
request ended
abnormally as an
incorrect value was set or
the execution condition
was not satisfied.
All
axes

- Confirm the setting values of the
parameters required for reading
cam patterns.
- Confirm if any axes are in
synchronous operation.
If any, cancel the synchronous
operation and read the cam
pattern tables.
* The details about the cause of
the occurrence of this warning are
stored in the "cam pattern reading
result" area of unit memories.
(Note): To simplify the displays, only the lower four digits (Hex) of each warning code are displayed in the above table.