Panasonic AFP7MC16EC, Руководство пользователя

Страница: 383 / 504

15.3 Error Code Table
15-19
● :
Recoverable, -: Unrecoverable
Error
code
Error name Description Object Recovered Countermeasures
4028H
Auxiliary output setting
error
The settings of auxiliary
output are not correct.
A mode other than With mode
or Delay mode has been set
for the auxiliary output mode.
The auxiliary output delay
ratio of Delay mode is not in
the range of 0 to 100 (%).
Each
axis

Check the set value.
If the error occurs
repeatedly with the
correct set values,
consult your Panasonic
representative.
4030H
Synchronous group
setting error
Either master axis or slave
axis has not been set.
Multiple master axes or slave
axes have been set.
The same axis has been set
for the master and slave axes.
A virtual axis has been set to
a slave axis.
Each
axis

4041H Completion width error
Completion width is out of the
range. Each
axis

4044H Speed rate error
The setting of the speed rate
is out of the range. Each
axis

4080H
JOG positioning
acceleration/deceleratio
n type error The acceleration/deceleration
method of the JOG
positioning is out of the range.
Each
axis

4081H
JOG positioning
operation acceleration
time error The acceleration time of the
JOG positioning is out of the
range.
Each
axis

4082H
JOG positioning
operation deceleration
time error The deceleration time of the
JOG positioning is out of the
range.
Each
axis

4083H
JOG positioning
operation target speed
error
The target speed of the JOG
positioning is out of the range. Each
axis

4102H
Home return target
speed error The target speed of the home
return is out of the range. Each
axis

4105H
Home return
acceleration time error
The acceleration time of the
home return is out of the
range.
Each
axis

4106H
Home return
deceleration time error
The deceleration time of the
home return is out of the
range.
Each
axis

4107H
Home return setting
code error The home return setting code
is incorrect. Each
axis

4110H
Home return creep
speed error The creep speed of the home
return is out of the range. Each
axis

(Note): To simplify the displays, only the lower four digits (Hex) of each error code are displayed in the above table.