PB
Press the
<NEXT>
soft key to view the
Auto Restart
screen.
Pressing the fourth soft key selects among the three
FLEXmax 80
Auto ReStart
modes: 0 (default), 1, and 2.
Auto ReStart
allows the FLEXmax 80 to perform internal
recalibrations.
•
Mode 0
—
Auto ReStart
mode is disabled; the FLEXmax
80 recharges continuously from an available source
and never
Restarts.
Mode 0 would be chosen to avoid
spinning a microhydro generator every 1.5 hours.
•
Mode 1
—once every 1.5 hours, when the FLEXmax 80
is in
Bulk
, it will briefly
Restart
and initiate a full panel
tracking. This will not reset any counters or charging
stages or statistics.
•
Mode 2
—
Auto ReStar
t every 1.5 hours; in
Bulk, Absorb
,
and
Float
modes, it will briefly
Restart
and initiate a
full panel tracking. This will not reset any counters or
charging stages or statistics.
ADVANCED MENU
RTS Compensation
A 14.4 V F 13.8V
EXIT NEXT LIMIT SET
AUTO RESTART
ADVANCED MENU
Auto ReStart
MODE 2
EXIT NEXT MODE
ADVANCED MENU
Auto ReStart
MODE 0
EXIT NEXT MODE
ADVANCED MENU
Auto ReStart
MODE 1
EXIT NEXT MODE
Содержание FLEXMAX 80
