Omron ZG -, Руководство пользователя

Страница: 181 / 210

Error Messages and Corrective Actions
179
ZG User’s Manual
5
APPENDICES
Error Messages and Corrective Actions
The following shows error messages that are displayed on the LCD screen and their
corrective actions.
*1: When the Sensor is not connected, the Controller screen darkens, making the error message no longer visible.
Error message Probable cause Reference
AUTO SETTING
FAILED Automatic setting cannot be executed on the current
region.
Set the region again referring to the manual. p.60
AUTO SCALING DO
NOT OPERATE
AB. THIS ITEM The auto-scaling function does not operate with cross-
sectional area and angle. p.71
REFERENCE
REGISTRTION FAILED Failed to register the reference for position correction.
1. Check whether or not teaching of the profile has been
successful.
2. Check whether or not the edge level has been set
correctly.
p.84
NO MEASUREMENT
POINT There is no measurement target.
Place the measurement target inside the measurement
range. p.72
SYSTEM ERROR
VDIN END ERR Communication with the Sensor is not possible.
1. Check the cable connection with the Sensor.
2. Check the cable for breaks.
If there is no problem with the above, a probable cause
is a Sensor or Controller malfunction. p.33
SCALING
FAILED The scaling correction range was exceeded.
Check the input values. p.71
SET VALUE ERROR
HIGH, LOW Review the setting values so that HIGH>LOW. p.51
SET VALUE ERROR
MAX, MIN Review the setting values so that MAX>MIN. p.91
p.93
CLEAR
BANK DATA When the CCD mode is changed, all bank data is
initialized. p.103
p.157
SENSOR IS NOT
CONNECTED
(*1)
Communication with the Sensor is not possible.
1. Check the cable connection with the Sensor.
2. Check the cable for breaks.
If there is no problem with the above, a probable cause
is a Sensor or Controller malfunction. p.33