![background image](http://html1.mh-extra.com/html/omron/sysdrive-3g3fv/sysdrive-3g3fv_user-manual_743234283.webp)
6-109
Overtorque Detection Timing Chart
Motor current
(Output torque)
Overtorque Detection 1 (N.O.)
or Overtorque Detection 2 (N.O.)
L6-02 or L6-05
L6-03
or
L6-06
L6-03
or
L6-06
See note.
See note.
Note The overtorque detection is cleared when the current drops about 5% of the Inverter’s rated cur-
rent (or the motor’s rated torque).
H
Hardware Protection Settings (L8)
Parameter
Display name
Setting
Units
Default
Valid access levels
number
p y
g
range
setting
V/f
Control
V/f with
PG
Open Loop
Vector
Flux
Vector
L8-01
DB Resistor Prot
0 or 1
---
0
Basic or Advanced
Note This parameter cannot be changed during operation.
Setting
Function
0
Disabled. (Select 0 when a braking resistor isn’t being used or a Braking Resistor Unit is being
used.)
1
Enabled. (Protects the braking resistor from overheating.)
Parameter
Display name
Setting
Units
Default
Valid access levels
number
p y
g
range
setting
V/f
Control
V/f with
PG
Open Loop
Vector
Flux
Vector
L8-02
OH Pre-Alarm Lvl
50 to 130
°
C
100
Advanced
L8-03
OH Pre-Alarm Sel
0 to 3
---
3
Advanced
Note These parameters cannot be changed during operation.
•
Parameter L8-02 specifies the detection temperature in
S
C for the Inverter overheat (OH) pre-alarm
function. An overheat pre-alarm occurs when the temperature of the cooling fins reaches this level.
•
Parameter L8-03 specifies the processing that will be performed when an overheat pre-alarm occurs.
Setting
Name
Function
0
Ramp to Stop
Decelerates to a stop in the deceleration time set in C1-09. (Fault)
1
Coast to Stop
Coasts to a stop. (Fault)
2
Fast-Stop
Emergency stop in the fast-stop time set in C1-09. (Fault)
3
Alarm Only
Continues operation. (Monitor display only.) (Minor fault)
Parameter
Display name
Setting
Units
Default
Valid access levels
number
p y
g
range
setting
V/f
Control
V/f with
PG
Open Loop
Vector
Flux
Vector
L8-05
Ph Loss In Sel
0 or 1
---
0
Advanced
Note This parameter cannot be changed during operation.
Advanced Operation
Chapter 6
Содержание SYSDRIVE 3G3FV
