6-30
6-4 Setting the Mode
Opera
tion
6
3. Different Model Codes
4. Executing Copying
5. Returning to Copy Mode
Key
operation
Display example
Explanation
The decimal point will move to the left when the
key is pressed for 3 s or
longer.
The model codes are being matched.
Press the
key to cancel copying before completion.
Key
operation
Display example
Explanation
Writing user parameters to the EEPROM of the Servo Drive will start.
The positioning parameters are copied.
The Servo parameters are copied.
This display indicates a normal completion.
Key
operation
Display example
Explanation
Press the
key to return to Copy Mode.
If
is displayed before completion, repeat the procedure from the
beginning.
Press the
key to clear the error.
If errors are repeatedly displayed, the following may be the cause: cable
disconnection, connector contact failure, incorrect operation due to noise,
or EEPROM fault in the Parameter Unit.
Do not disconnect the Parameter Unit from the Servo Drive while copying
is being performed. If the Parameter Unit is disconnected, incorrect data
may be written and the data may be corrupted. Copy the user parameters
again from the source Servo Drive to the Parameter Unit, and then copy
the user parameters from the Parameter Unit to the other Servo Drive.
ekekpk_kckh
-k-
pkok5k_kp
ckp
skrkUk_kp
ckp
Precautions
for Correct Use
