Omron NT-SERIES - SUPPORT TOOL FOR WINDOWS V4, Руководство по эксплуатации

Страница: 182 / 594

6-3 Section Alarm
166
NT21, NT31, NT31C, NT631, and NT631C:
Specifies whether or not the screen is switched when the message dis-
played at the alarm list is pressed.
The following table shows the appropriate setting of the bit memory table for the
required alarm processing, for your reference.
NT30, NT30C, NT620S, NT620C, and NT625C:
Usage of Alarm
Setting for Bit Memory Table
Usage of Alarm
Function Setting Switch Screen Screen No.
To display alarm only
Alarm/Switch
Screen
OFF 0
To display alarm and
switch to a specified
screen in response to
the pressing of alarm
message
Alarm/Switch
Screen
OFF As desired
To switch to a speci-
fied screen at the
same time the bit
goes ON
Alarm/Switch
Screen
ON As desired
To switch to the pre-
vious screen at the
same time the bit
goes ON (Switch to
the previous screen
based on the record
of screen history)
Alarm/Switch
Screen
ON 0
NT21, NT31, NT31C, NT631, and NT631C:
Usage of Alarm
Setting for Bit Memory Table
Usage of Alarm
Function Setting Switch Screen Screen No.
No function (For reg-
istering only allocated
bits and securing
them)
None – –
To display alarm only Alarm OFF –
To display alarm and
switch to a specified
screen in response to
the pressing of alarm
message
Alarm ON As desired
To switch to a speci-
fied screen at the
same time the bit
goes ON
Switch screen – As desired
When converting the bit memory table from the NT30,
NT30C, NT620S, NT620C, NT625C to the NT21, NT31,
NT31C, NT631, NT631C, the function setting is not the
same with before converting. To adjust the setting of this
bit memory table, please refer to
Data Conversion (Bit
memory conversion ) in Appendix A .
WARNING