Omron NT-SERIES - SUPPORT TOOL FOR WINDOWS V4, Руководство по эксплуатации

Страница: 174 / 594

6-2 Section Fixed Display
158
Selection using the drawing toolbar:
Property setting
General
Position: Indicates the display position of library data.
(The attribute point is at the upper left corner in the library data.)
Size: Indicates the size of library data. (frame size of the library
data)
Reference Type
Direct: Set the library code directly.
Code: Indicates the code of the library data to be displayed.
Comment: Displays the comment that is set for the library data.
Indirect: Set this item when the value for the specified numeral table
entry is treated as library code and referenced indirectly.
Table No.: Specify the numeral table entry to be referenced.
When using the indirect reference, set the storage type of allo-
cated numeral table entry to Binary. Also, when specifying the
library code from a program etc., use hexadecimal value since
the library table code is in hexadecimal.
: Displays the list for selecting the library data when Direct is
specified. Displays the list for referencing the numeral table
entry when Indirect” is specified.
Guidance
When the library data is specified, the data of character code FA20H (for the
NT30, NT30C, NT620S, NT620C, NT625C, NT21, and NT31/631-V2 and
above with NT20/30/620-compatible mode), or the data that corresponds to
image/library code 1000H (for the NT21, NT31, NT31C, NT631, NT631C with-
out NT20/30/620-compatible mode) is arranged.
The mark shown below will be displayed if library data has not been created for
the specified code.
To change the library data to be displayed, click on in the property and se-
lect the desired library data or numeral table entry from the list.
If you are using the NT31, NT31C, NT631 or NT631C “-V1” and above, and its
system program version is 2.1 and above, “Indirect reference” can be set.
The procedure for specifying the desired library data is shown below.
Direct
Specify the code of the library data to be displayed directly.