Omron E5ZD, Руководство по эксплуатации

Страница: 125 / 157

115
One, two, or all three of these special designations may be made at any time,
depending on the header code (see table below).
@ 0 Unit Bank Point CR
Header code
Header
code
Data code FCS
*
Terminator
Setting
4 or 5 digits
0 to F 0 to 7, A 00 to nn
0 to 7, A
Data code “nn” FCS
*
CR
Header code
@ 0 Unit Bank Point A A
Data code “00”
Data code 4 or 5 digits
0 to F 0 to 7, A
0 to 7, A
4 or 5 digits Terminator
Response Formats The responses returned for these commands are shown below. These
responses assume that the header code in the command block was transmitted
and read normally. If the header code in the command block was not
recognizable, a header code of IC will be returned without an end code (see
Section 4-1-2 End Codes for the IC header code response format).
@ 0 Unit CR
Header code
*
Terminator
End code FCS
End Codes If an end code of 00 was returned in the response, the command was executed
normally. If the end code is not 00, the desired data will not have been written.
Refer to
Section 4-1-2 End Codes for a description of the other possible end
codes and their meanings.
Global Write Operations Control point numbers are listed for 8-point models.
Header
Code
Memory
Bank
Point Data
Code
Operation
W# 0 0 to 7 00 Writes alarm 1 mode as specified.
01 Writes alarm 2 mode as specified.
AA Writes alarm 1 and 2 modes as specified.
A 00 Writes alarm 1 modes for all points.
01 Writes alarm 2 modes for all points.
AA Writes alarm 1 and 2 modes for all points.
Global Write Operations
Section 4-5