Omron E5ZD, Руководство по эксплуатации

Страница: 121 / 157

111
Command Example
The following command is used to read the fuzzy strength from memory bank 3
of point 2 in unit 1.
*
@ 0 1 R j 3 2 0 0 7 8
s
Response Formats
When the host computer sends an Rj, Rk, or Rl command, the Temperature
Controller respond according to the command. The responses returned for
these commands are shown below.
The following response will be returned when the header code has been read.
@ 0 Unit R j/k/l 0 0
s
Header code Terminator
Set value
FCS
*
End code
End Codes
If an end code of 00 was returned in the response, the command was executed
normally. If the end code is not 00, the desired data will not have been read. Re-
fer to
Section 4-1-2 End Codes for a description of the other possible end codes
and their meanings.
4-4 Global Read and Control Operations
The memory bank, control point, and data code designations can be specially
defined to allow certain commands to be globally applied. Such commands can
be used to control the operation of, or read out data for, all control points, all
memory banks for a specified control point, or all data codes with the same
header code. The commands for global read and global control operations are
listed in the table at the end of this section.
Command Format The format for this command is as shown below. The unit number, header code,
memory bank, control point, and data code must be identified with a special des-
ignation which specifies the group to be acted on, i.e., memory banks, control
points, or data codes.
If “A” is used for the control point, all of the control points for the specified Unit are
specified; if “A” is used for the memory bank, all of the memory banks for the spe-
cified control point are specified; if “AA” is used for the data code, all possible
data codes with the specified header code are specified.
Only one of these special designations may be specified at any time. In addition
“A” cannot be specified for the memory bank at the same time as “AA” is speci-
fied for the data code.
@ 0 Unit Bank Point CR
*
Terminator
FCS
Header code
Data code
0 to F 0 to 7, A
0 to 7, A
00 to nn, AA
Global Read and Control Operations
Section 4-4