Omron E5ZD, Руководство по эксплуатации

Страница: 145 / 157

135
Appendix C
End Codes
The following is a list of end codes which are returned with responses to commands to indicate the execution sta-
tus of the command. (If the command was not recognizable, a header code of IC is returned without an end code.)
These end codes are explained in more detail in the body of this manual.
End code Name Meaning
00 Normal completion The command was executed correctly.
01 Invalid command An command was sent that could not be executed under current operating con-
ditions.
04 Invalid address The control point or memory bank designation is out of range.
10 Parity error The parity bit was wrong.
11 Framing error The stop bit was not detected.
12 Overflow error The reception buffer has overflown.
13 FCS error The FCS value was incorrect.
14 Format error An incorrect format was used for the command.
15 Numeric error Data was not within specified limits.
18 Frame length error The command block exceeded 127 characters.
19 Invalid command due to
parameter restrictions Execution of the command is not possible because of parameter settings
21 Error status Command execution is not possible because an error has occurred in the
E5ZD.