Omron E5ZD, Руководство по эксплуатации

Страница: 109 / 157

99
End Codes If an end code of 00 was returned in the response, the command was executed
normally. If the end code is not 00, the desired data will not have been read. Re-
fer to
Section 4-1-2 End Codes for a description of the other possible end codes
and their meanings.
4-2-23 Transmission Test: TS
This command is used to test communications between the host computer and
the E5ZD. If the test is successful, the E5ZD will return the same character string
as it received.
Command Format The format for this command is as shown below. The unit number is required
along with the character string that is to be returned.
@ 0 Unit T S CR
Header code
Terminator
*
118characters max.
Characters string
FCS
Response Format The response returned for this command is shown below. This response as-
sumes that the header code in the command block was transmitted and read
normally. If the header code in the command block was not recognizable, a
header code of IC will be returned (see
Section 4-1-2 End Codes for the IC head-
er code response format).
There is no end code returned for this command; the character string is used to
determine the success of the test.
@ 0 Unit T S CR
Header code
Terminator
*
Character string
FCS
The command and response formats for successfully sending the test string
“ABC123” to Unit 1 are shown below.
Command
@ 0 1 T S A B C 1 2 3 3 6 CR
*
Response
@ 0 1 T S A B C 1 2 3 3 6 CR
*
End Codes End codes are not used in the response to this command.
4-2-24 Initialize Parameters: MC
This command is used to reset RAM to the factory-set default parameters. Only
the parameters shown in the table below are reset; all others will retain their cur-
rent values.
Command/Response
Examples
Temperature Control Commands (All Controllers)
Section 4-2