Omron E5ZD, Руководство по эксплуатации

Страница: 143 / 157

133
Appendix B
Parameter Defaults, Setting Ranges, and
Commands
This appendix provides a list of the commands according to the parameters or operations that they control. It also
provides the factory-set defaults, the number of digits required to set the parameter, and the parameter’s setting
limits.
Where possible, commands are given in write-read pairs for the same parameter or operation. The “Write code” is
the header code used to write the parameter or operation; the “Read code” is the header code used to read the
parameter or status. If the same header code is used for more than one command, the data code is provided with it.
Refer to the body of this manual for details.
Commands Controlling Operation
Command Write code Read code Digits
Operation Start OS RX-02 0
Operation Stop OP RX-02 0
Autotuning Start AS RX-02 0
Autotuning Stop AP RX-02 0
Commands for Parameters Independent of Control Points
Parameter Write code Read code Digits Default Upper Lower Remarks
HB/HS Alarm Point WU-02 RU-02 4 0000 0000 00FF Bit data
Output Mode WU-00 RU-00 4 0000 0000 00FF Bit data
Commands for Parameters for Individual Control Points
Parameter Write code Read code Digits Default Upper Lower Remarks
Memory Bank
Designation WM RM 4 0000 0000 0007 ---
Alarm Modes 1 and 2 W# R# 4 0000 0000 000C ---
Detection Level WW RW 4 0000 0000 0500 0.1 A unit
Commands Controlling Operations
Command Header code Digits Remarks
Initialize Parameters MC 0 ---
Transmission Test TS 118 ---
Undefined Error IC NA Returned in response for unrecognizable command
EEPROM Write WE NA Writes RAM contents to EEPROM