Omron CX-PROGRAMMER V9, Руководство по эксплуатации

Страница: 138 / 536

PART 1: CX-Programmer
OMRON CHAPTER 3 – Project Reference
CX-Programmer _Page 55
The command works according to which tab the output window is showing (compile, find report or transfer).
Go To
The Go To options are available in Mnemonic and Ladder Diagram views and enable jumps to a required
location in the program.
Rung / Step Number
It is possible to jump the display to show a particular location in a program or section. A location can be
specified by either its rung or step number.
The Go To dialog allows a choice of specifying the rung or step number. The range of valid rung or step
numbers is shown. Use the key combination
Ctrl+G to display this dialog.
Note: When the dialog has been accessed from a program level (i.e. when viewing the program
section list, or from the program level on the project workspace), it is possible to jump to any
point within the whole program. However, since rung numbering is per section, only steps
may be used for referencing in this case. The step range will show the entire range within the
program.
The dialog also has a rung browse function, accessed from the Browse button. The browser lists the sections
within the program and the commented rungs within each section. A rung may be chosen for viewing from this
list.
When the dialog Go To button is pressed, the requested location is brought into view.
Commented Rung
The Commented Rung dialog shows a list of rungs within sections that have been given comment properties.
Use the shortcut key
L to display this dialog. The first line of a rung’s comment is shown in a numbered list (the
numbers start from 1 and do not indicate the rung number).
A list of sections is given above (when the function is accessed from the program scope).