Set An IP Address
2-6
❖
DP Technical Information Guide
Dynamic Addressing
(RARP/BOOTP)
The TCP/IP address is assigned automatically by the Server. Follow
the steps below:
1
Power the printer ON and allow time for an IP address to be
assigned by the RARP/BOOTP server (this time may vary
depending on network traffic).
2
Perform the steps contained in the section “Print the Configuration
Sheet” (page 2-11).
3
Obtain the hardware and TCP/IP addresses from the Configuration
Sheet.
4
Update the RARP/BOOTP server’s /etc/ethers, and the /etc/hosts
files with a host name, TCP/IP and hardware addresses. Consult
your UNIX documentation for more RARP/BOOTP server
configuration details.
Содержание DP
