Page: 69
Service Guide OF1000
Chapter 3 Maintenance & Disassembly
3.2.03 Terminal Cover Cap, Rear Cover, and Fan
1. Perform this procedure:
3.2.01
2. Remove the screw (1).
3. Remove the terminal cap cover (2).
NOTE:
You do not have to remove the terminal cover cap to remove the rear cover and fan.
4. Remove the two screws (3).
5. Detach the rear cover (4) and tilt it out to access the fan cable (5).
6. Detach the fan cable from connector CN11 (6) from the board (PCNT) (7).
7. Release the latches (8) and remove the fan (9).
8. Remove the rear cover.
NOTES:
The fan connector cable goes to CN11 of the PCNT board. This is a 3 pin connector.
When installing the rear cover, be careful not to damage the ring volume switch cover.
When installing the fan, be careful not to leave the cable in front of the fan. Be sure to place the
cable on the side of the fan. If you do not, it may cause excessive vibration noise or prevent the
fan from operating. If fan motion is stopped completely, a PRINT ALARM 3 will be displayed on
the operator panel.
P/N N/A Screw
B.2.01
P/N 53070206 Cover: Terminal Cap
RSPL B.2.01
P/N 53070002 Cover: Rear
RSPL B.2.01
P/N 56510902 Fan
RSPL B.2.01
, B.2.16
Содержание OF1000
