OKIDATA ML393C Plus, Руководство по обслуживанию

Страница: 230 / 323

Page: 153
Service Guide ML393/ML393CPlus
Chapter 4 Failure Analysis
4.8.03 Font Test
General Information
This test will print samples of the available fonts.
The standard fonts are listed below. The cartridge fonts will depend on the cartridge installed.
LQ - ROMAN 10 cpi, Proportional, Super / Subscript
LQ - SWISS 10 cpi, Proportional, Super / Subscript
LQ - COURIER 10 cpi,12 cpi, 15 cpi, 17.1 cpi, 20 cpi, Proportional, Super / Subscript
LQ - ORATOR 10 cpi, 12 cpi, Super / Subscript
LQ - 12 cpi
UTILITY - 10 cpi, 12 cpi, 15 cpi, 17.1 cpi, 20 cpi,
HSD - 15 cpi
LQ - SWISS Double Width / Height
LQ - SWISS 18 point with Outline
LQ - SWISS 18 point with Shadow
LQ - SWISS Triple Width / Height
Header Information
At the top of the printout, you will see the Printer Model, Emulation, Country Code, Interface Selection and
Firmware Revision Level. This information is often required when performing service or when contacting
Okidata. Have this test available during your service call.
Procedure
1. Verify that the printer is loaded with paper.
2. Power OFF the printer.
3. Press and hold the LINE FEED switch while powering ON the printer. If the font test does not print after
you power ON the printer, you may have released the LINE FEED switch too soon.
4. To stop the test, press the SELECT switch or power OFF the printer.
Font Test Sample