![background image](http://html1.mh-extra.com/html/okidata/ml393c-plus/ml393c-plus_service-manual_729925222.webp)
Page: 148
Service Guide ML393/ML393CPlus
Chapter 4 Failure Analysis
RAP 10C: Serial Interface Problem
START
Correctly set the interface menu parameters.
1. Baud rate.
2. Character format.
3. Protocol.
4. Busy signal polarity.
Has the problem been resolved?
YES End of procedure.
NO Are +/-8 vdc outputs provided on the control board?
Check at both ends of C9 for the positive voltage.
Check at both ends of C8 for the negative voltage.
NO Replace the power supply unit.
YES Refer to RAP 10B.
Has the problem been resolved?
YES End of procedure.
NO Replace the power supply board.
Has the problem been resolved?
YES End of procedure.
NO Perform the procedures listed below.
1. Replace the interface connector board.
2. Replace the cable connected to CN6 on the control board.
Copyright 1997, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business
Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)
Содержание ML393C Plus
Страница 74: ...Partner Exchange BPX for any updates to this material http bpx okidata com...
Страница 125: ...Copyright 1997 Okidata Division of OKI America Inc All rights reserved See the OKIDATA Business...
Страница 126: ...Partner Exchange BPX for any updates to this material http bpx okidata com...
Страница 278: ...Partner Exchange BPX for any updates to this material http bpx okidata com...