Page: 70
Service Guide ML393/ML393CPlus
Chapter 3 Maintenance
3.2.18 Carriage and Carriage Shaft
Procedure
1. Remove the printhead
(3.2.01
).
2. Remove the upper cover assembly
(3.2.04
).
3. Loosen the screw (1) and slide it towards the back of the printer. This screw affects the placement of
the slide guide (1A).
4. Loosen the mounting screw (2) and detach the left eccentric collar (3).
5. Remove the screw and detach the blue printhead gap adjusting lever.
(Not shown)
6. Loosen the screw (4) and detach the right eccentric collar (5).
7. Remove the two stopper cushion rings (6).
8. Slide the carriage shaft (7) to the right and remove the carriage (8) and round spacer (
Not Shown
).
9. Continue sliding the carriage shaft to the right, then remove the carriage shaft.
NOTE:
Installation
The protrusions on the eccentric collars face the outside of the printer.
The long extension end of the carriage shaft goes to the right side of the printer.
The printhead gap adjust lever is NOT shown. Refer to Appendix B of this Service Handbook for further
information.
When cleaning, refer to Section 3.4 of this Service Handbook
.
Perform the printhead gap adjustment after installation. Refer to Section 3.3
of this Service
Handbook for further information.
The parts list appears on the following pages.
Содержание ML393C Plus
Страница 74: ...Partner Exchange BPX for any updates to this material http bpx okidata com...
Страница 125: ...Copyright 1997 Okidata Division of OKI America Inc All rights reserved See the OKIDATA Business...
Страница 126: ...Partner Exchange BPX for any updates to this material http bpx okidata com...
Страница 278: ...Partner Exchange BPX for any updates to this material http bpx okidata com...
