OKIDATA ML393C Plus, Руководство по обслуживанию

Страница: 164 / 323

Page: 106
Service Guide ML393/ML393CPlus
Chapter 3 Maintenance
3.3.09 Forms Tear Off
General Information
This feature (when activated) will automatically advance continuous feed paper to the tear-off position
after it finishes printing the last page in the document. A few seconds after printing stops, the printer will
move the paper up to the tear-off position, aligning the perforation with the serrated edge on the access
cover. The operator will be able to tear off the last printed page without wasting paper or adjusting the
printer. When the printer receives data to print, it will automatically return the paper to the top of form
position for printing.
Forms Tear Off can only be used with continuous feed paper fed in from the rear on the built-in push
tractor. It CANNOT be used with the optional pull tractor.
NOTES:
Some programs, such as high resolution graphics packages, pause occasionally while sending data to the
printer.
If the pause lasts more than the selected interval, the paper will advance to the tear-off position until more
data is received.
No data is lost, but the extra paper movement causes uneven print registration.
If this problem occurs, disable (set to OFF) the Menu Setting for Forms Tear Off.
Procedure
1. Load continuous feed paper into the printer.
2. Verify that the ribbon is installed.
3. Power ON the printer.
4. Verify that the printer is ON-LINE (SELECT lamp is lit).
5. Press SELECT and place the printer OFF-LINE (SELECT will not be lit).
6. Press QUIET to enter Menu Mode.
7. The line shown below will print.
Font Print Quality <current setting>
8. Press GROUP until the following line is printed.
Vertical Control Emulation Mode <current setting>
9. Press ITEM until the following line is printed.
Vertical Control Form Tear Off <current setting>
10. Press SET to change the menu setting for Form Tear Off.
To activate Form Tear Off, the setting must be 300 mS, 1 sec., or 2 sec.
To deactivate Forms Tear Off, the setting must be OFF.