OKIDATA ML393C Plus, Руководство по обслуживанию

Страница: 140 / 323

Page: 88
Service Guide ML393/ML393CPlus
Chapter 3 Maintenance
3.2.32 Roller Supports and Rollers (H)
1. Power OFF the printer.
2. Remove the cut sheet feeder.
3. Disengage the rear-bin unit from the front-bin unit (3.2.30 ).
4. Remove the left and right side covers from the front and rear bin units (3.2.31 ).
5. Remove the three screws (2).
6. Slide the control board (3) in the direction of arrow A. [Single-bin units ONLY]
7. Remove the E-shaped snap ring (4).
8. Pull the hopper shaft (5) in the direction of arrow B.
9. Remove the left roller support (6).
10. Remove the right roller support (7).
11. Remove the roller H (8). The collar (9) will also be removed at the same time.
12. Remove the rollers H (8) from the left roller support (6) and the right roller support (7).
NOTE:
Installation
When installing the roller support bearings, be sure to install the blue side on the right and the white side
on the left.
When installing the hopper shaft (5), fit the flanges of the left roller support (8) and right roller support (7)
into the grooves of the sheet guide A (10) and sheet guide B (11).