ODA EX 100-12, Руководство пользователя, Страница: 20 / 94

2-1. Front-Panel setting of Voltage and Current
You can set the voltage and current limit values from the front panel using the following method.
1. Confirm the display of "OUTPUT OFF" on the LCD after turning on the power supply.
2. Press the "Limit Display" key to show the limit values (setting mode) on the display.
3. Left cursor key is for voltage setting from fine to course, also right cursor key is for current
setting from course to fine.
4. About both of encoder knob, left encoder is for voltage value increasing or decreasing.
Right encoder is for current value increasing or decreasing.
5. In order to increase the volt/curr limit value, turn the encoder clockwise.
In order to decrease the volt/curr limit value, turn the encoder counter clockwise.
6. Confirm the change of setting value at LCD display
7. In order to output the setting voltage & current, press "OUTP ON/OFF" key.
If the power-on self-test fails, the ERROR annunciator turns on and then press the "Error Key"
in order to confirm the error code. For further information of Error code, Please refer “7. Error Messages”.
About error code, refer to “7. Error Messages
When the instrument is operating under the remote interface, The keys and Encorders of Front panel
is not working. In order to control by front panel key, press the "IO/Local Key" for local control
after stopped the remote Interface operating.
- 21 -
Note3
Note1