NSK MEGATHRUST ESA-LYB2T15-21, Руководство пользователя

Страница: 92 / 234

— 8-15 —
8.4. Setting Filters (Adjustment Level 2)
l
When positioning, the Motor may resonate mechanically and generate a noise of certain
frequency. Using Megathrust Motor’s software “low-pass filters” (Parameter FP and FS), the
noise can be reduced.
The unit of parameters of FP and FS is cycles / second (Hz).
à
If low frequency less than 100Hz is set to parameters “FP” and “FS”, hunting or
unstable positioning may occur.
l
Before using filters, make sure that all adjustments of gain (VG) and integrator frequency (VI)
are completed.
l
Use same demonstration program (SA/AJ) for adjusting filters. Follow the procedures a ~ j in
“8.2.4. Trial Running (Adjustment Level 1)”.
(1) Start “FP” adjusting program.
[+],[-],[ENT]
444( 333)
STEP1
_FP500
P / F J
ENT
A
(i)
(v)
(ii)
(iii) (iv)
The message is displayed as shown below. Press plus (+) or minus (key) to change “FP” value.
(The display shown below is an example. Those values shall be set to the conditions for actual
use.)
l
Explanation of the messages
(i) Key function
and
-
+
SHIFT
: Pressing key one time increases 10 resolution of “FP”.
-
+
: Pressing key one time decreases 10 resolution of “FP”.
ENT
: Store “FP” value in the memory and completes the
(ii) Indicates present “FP” value.
(iii) Indicates “FP” value changed by pressing plus (+) or minus (-) key.
(iv) Response index number : The lower number denotes better response.
(v) Positioning index number : The lower number denotes quicker positioning.
positioning.
Note: Changing “FP” step (3).
If you want to change the resolution of step, press space key or back space key.
Space key : Changes the step to 1/10 of present resolution.
(Pressing twice makes 1/100.)
Back space key : Changes the step to 10 times of present resolution.
(Pressing twice makes 100 times.)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com