Nordson Encore iControl 2, Конфигурация, Настройка предустановок, Операция

Страница: 84 / 168

Ethernet and Gun Mover Configuration
4-28
Part 1056418-07
E 2019 Nordson Corporation
Analog Scanner Configuration
Touch the Photoeye and Scanner Configure button on the System
Configuration screen to open the Photoeye and Scanner Configuration
screen.
NOTE: This feature requires analog scanners supplied and configured by
Nordson Corporation.
The analog scanners are used to measure the part width and height for
positioner and reciprocator control. They can also be used for zone
detection, as described in Section 3, System Configuration . The analog
scanner controllers communicate with the iControl system over the Ethernet
network.
For most systems, one or two horizontally mounted scanners are used to
detect part width for horizontal (in/out) positioners, while a vertically
mounted scanner is used to detect the part height for reciprocators or for
vertical (up/down) positioners.
For analog scanners, separation between the emitter and receiver should
be no more than:
S
6 meters (20 ft) if the scanner is less than 1.2 meters ( 4 ft) long
S
4.5 meters (15 ft) if the scanner is more than 1.2 meters (4 ft) long.
Analog Scanner Enable
See Figure 4-23. To enable analog scanners and open the scanner
configuration screen:
1. Enable the scanners.
2. Enter the number of horizontal scanners (1 or 2).
3. Touch the scanner Configure button to open the Scanner Configuration
screen.
Configure
Number of
Horizontal
Scanners
Enable/
Disable
Figure 4-23 Enabling and Selecting Number of Horizontal Scanners