Nipro SURDIAL, Руководство по обслуживанию, Страница: 223 / 334

9.10-3
9.10.2. ROM after Ver.3.00
INDICATION DESCRIPTION
1.SYRINGE RATE Setting of cross-sectional area ratio of syringe intended to
be used to NIPRO syringe as 100%. When the ratio is
50%, infusion rate is doubled.
2.BP STOP AFTER POWER FAIL Setting to ON when blood pump SW is turned off at return
to normal after power failure
3.V,A,DP ALARM RESETTING Setting of time required to reset upper/lower alarm limit s
of venous, arterial and dialysate pressure during dialysis
4.DISINFECTION RATIO Setting of dilution rate of Na hypochlorite in disinfection/
rinse
5.ACID RATIO Setting of dilution rate of acetic acid in acid rinse
6.HOT DISINFECTION RATIO Setting of dilution rate of chemical liquid in hot disinfection
rinse (option)
7.HOT WATER RINSE TEMP. Setting of temperature in hot water rinse (option)
8.HOT DISINF. TEMP. Setting of temperature in hot disinfection rinse (option)
9.VP MAX ALARM LIMIT Limiting of allowable upper venous pressure alarm limit
10.VP MIN ALARM LIMIT Limiting of allowable lower venous pressure alarm limit
11.AP MAX ALARM LIMIT Limiting of allowable upper arterial pressure alarm limit
12.AP MIN ALARM LIMIT Limiting of allowable lower arterial pressure alarm limit
13.DP MAX ALARM LIMIT Limiting of allowable upper dialysate pressure alarm limit
14.DP MIN ALARM LIMIT Limiting of allowable lower dialysate pressure alarm limit
15.INITIAL UF GOAL Setting of initial value of target UF volume
16.INITIAL UF RATE Setting of initial value of UFR
17.MINIMUM UF Setting of minimum UFR
18.TMP OFFSET Setting to ON when TMP calculation is used
19.ACID PORT OPTI0N Setting to ON when acid rinse port (option) is used
20.ART. PRESSURE OPTION Setting to ON when arterial pressure sensor (option) is
used
21.BACK UP OPTION Setting to ON when back-up unit (option) for power failure
is used
22.HOT RINSE OPTION Setting to ON when hot rinse Assy is used
23.SYRINGE OPTION Setting to ON when syringe pump is used
24.CONSOLE MODE Setting to ON when operated in console mode
25.MAINTENANCE MODE FREE Setting to ON when protected settings in MODE 2 and
MODE 4 to MODE 7 are released