26
Manual movement and release:
before carrying out this operation please note that release can only occur when
the leaf is stopped.
1.
Pull the release cord down until you hear the release of the carriage.
2.
The door can now be moved manually
3.
To restore automation operation return the door to the initial position until you hear the carriage engage.
Control with safety devices out of order:
If the safe-
ty devices are malfunctioning, it is still possible to control
the door.
• Operate the door control device (remote control or key-
operated selector switch etc.). If the safety devices
enable the operation, the door will open and close nor-
mally, otherwise the flashing light flashes a few times
but the manoeuvre does not start (the number of flash-
es depends on the reason why the manoeuvre is not
enabled).
• In this case, actuate the control again within 3 seconds
and keep it actuated
.
• After approximately 2 s the door will start moving in the
“man present” mode, i.e. so long as the control is main-
tained the door will keep moving; as soon as the con-
trol is released the door will stop.
If the safety devices are out of order the automa-
tion must be repaired as soon as possible.
Replace the Remote Control Battery:
if your radio
control after a period of time, seems not to work as well,
or not to work at all, it may simply be that the battery is
exhausted (depending on the type of use, it may last from
several months up to one year and more). In this case you
will see that the light confirming the transmission is weak,
or does not come on, or comes on only briefly. Before call-
ing the installation technician try exchanging the battery
with one from another operating transmitter: if the problem
is caused by a low battery, just replace it with another of
the same type.
Warning:
The batteries contain polluting substances: do
not dispose of them together with other waste but use the
methods established by local regulations.
1. Press the white cover and turn to remove.
2. Push the lamp up and rotate to remove. Insert a new
12V / 21W lamp with BA15 socket.
Lamp replacement:
before proceeding, disconnect SPIN from the power supply.
Are you satisfied?
If you wish to install another automation system in your home, call your old installation technician
and use Nice products. You will get the services of a specialist and the most advanced products available on the mar-
ket, superior performances and maximum system compatibility.
Thank you for reading these instructions. We feel confident that you will be well satisfied with your new system: for any
present of future requirements, please contact your reliable installation technician.
