7
GB
3.2.1) Assembly of guide supplied with SPIN10KCE
The guide supplied with SPIN10KCE must be assembled as follows:
1.
Lay the three guide parts to enable them to be joined.
2.
Extract the belt tightener (A) as in figure 8A, pass one end of the belt as in figure 8B and replace the belt tightener (A) as in figure 8C.
3.
Pass the same end through the head (B), as in fig. 9, taking care that the belt is correctly positioned: the teeth should be facing inwards,
and should be straight with no twists.
4.
Turn the lower carriage as in figure 10
5.
Place both ends of the belt in the all of the shaped slot of the lower carriage (C), and fix the two ends with the two V4.2x9.5 screws and
two R05 washers, as in fig. 11.
6.
Fix the leaf connecting bracket (D) to the upper carriage (E) with the V6x18 bolt and related M6 nut, as in fig. 12.
7.
Connect the upper carriage (E) to the lower carriage (C) and position the entire carriage assembly inside the guide, as in fig. 13.
8.
Assemble the end of the guide (B), as shown in figure 14. This requires a certain force; if necessary use a rubber mallet.
9.
Using joining brackets (F), fit the three parts (G) together as shown in figures 15 and 16.
10.
Tension the belt by means of the M8 nut (H), as shown in figure 17, until it is sufficiently taut.
8A
8B
8C
10
A
11
12
13
C
14
16
15
17
B
F
F
G
G
G
H
D
E
E
C
B
9
A
A
