PEAK
With this selected, whenever a meter peaks the topmost LED will remain
lit for two seconds or until it is overwritten by a louder signal.
P/HOLD
With this selected, the metering will permanently display a single LED to
show it's loudest peak until it is overwritten by a louder signal.
This can be reset by pressing the
P/HOLD
button again.
In this way, it is possible to play a section of music and then determine
the loudest spike on each path.
DAW
Lights red whenever the
DAW
button is pressed on the Control Room
Panel and indicates that the 8T meters are being fed from the DAW
metering and not the console metering.
PSU STATUS
Indicates the state of the internal console power supplies.
If all power supplies to all sections of the console are healthy, then all leds
will be
OFF.
The
1
,
2
,
3
&
4
leds refer to a particular 16 channel section of the
console, with
1
referring to the 33-fader centre section of the Genesys
Black.
As Genesys Black is scalable up to 56 channels, each of the 1 – 4 leds
refer to a block of 16 channels:
Led
Console Fader Section
1
1–8 + DAW
2
9-24
3
25-40
4
41-56
If a power supply should fail, 2 or more leds will light:
•
One of the
1
,
2
,
3
or
4
leds will indicate the section of the
console;
•
One of the
+48v
,
+5v
,
+18v
or
-18v
leds will indicate which
supply within that section.
For example, if
2
and
+48v
were lit, this would indicate there is no +48v
(phantom power) supply on fader section 9-24.
- 94 -
