To Route
8T Outputs
to Specific Loudspeakers
It is possible to route the 8T Outputs directly to individual loudspeakers.
u
Press and hold down
LOCK
on the Main Monitor Panel, then press
RTE
SEL
to enter Master SEL mode.
The
RTE SEL
button will flash, along with all of the console
SEL
leds.
Most of the Monitor Panels buttons will have their functionality blocked
out.
u
Press
8T.
u
It is now possible to scroll through all of the 8T Outputs using the
Monitor Knob, the selected 8T appearing on the alpha display (if there are
routes already in place, as you scroll through the 8T paths using the
Monitor Knob these will be displayed via the Loudspeaker
CUT
buttons).
u
When you have selected the 8T you wish to configure, select the
loudspeaker you wish to send this path to using the individual LS
CUT
buttons. The speaker button will light when selected.
It is possible to send any of the 8T Outputs to more than one speaker
destination at a time.
u
Exit Master SEL Mode by pressing
RTE SEL
to lock these routes into
place.
2T
Lights yellow and flashes when selected and allows setup of the
2T
mixer.
When Master SEL mode plus 2T is selected, it will open the 2T
Setup screen as shown above.
It is possible to set up the 2T mixer using the 2T Mon SEL or 2T screen to
configure the following:
5.1 mode or Group mode
:
Group mode is useful for folding down stereo groups. The 5.1 mode will
set up your Down Mix of the 5.1 mix being made by the 8T system.
Pre / Post
:
- 80 -
