M2 SEL
Lights yellow when selected and allows
PFL
or the
RTB
to be sent to the
M2 speakers if they are not being used for other monitoring purposes.
•
The 1st press will send the
PFL
buss to
M2 any time
a Solo
button is pressed on the console.
•
The 2nd press will set
RTB
to be sent to the M2 speakers.
•
The 3rd press will return the
M2
speakers to their default state.
The function of
M2 SEL
will be shown on the associated leds.
M2 SEL
will be temporarily suspended if M2 LS is selected, and will return
to it's original state if
M2
is deselected.
NB:
It is also possible to activate RTB remotely, via the DC Remote
connector.
This will switch on
M2 SEL
and flash the
RTB
LED on the monitor panel to
show remote selection.
SWP
Lights yellow and sends the rear Left and Right speakers to the front Left
and Right, cutting the LS and RS speakers.
This enables the rear Surround image to be heard on the front speakers
for better balancing.
A, B, M1
&
M2
Lights yellow when pressed and selects sets of loudspeakers.
•
A
and
B
are both Surround sets of speakers.
•
M1
and
M2
are both Stereo sets of speakers.
The
M1
speaker outputs appear on XLRs on the rear of the console for
convenience.
It is possible to tie a set of loudspeakers to the Stereo fold-down as
described in
ST
, and also which speaker set is locked to the Sub and Left
Surround / Right Surround.
See section below on Master SEL Mode.
S
&
LS/RS
leds
Lights red whenever
B,
M1
or
M2
loudspeaker sets are selected with ties
set, either on the
LS Settings Screen
or using Master SEL mode and the
LS selector buttons.
LS SOLO
LED
This red LED will light to show that the 6
LS
CUT
buttons are now in
destructive mode and non-latching.
This mode allows for any of the buttons to be lit by selection of any of the
CUT
buttons ie if you were to select
L CUT
, then all the rest would light
(apart from
L CUT
).
If a Master Cut is selected, it will suspend LS Solos until deselected.
The setting of this mode using Master Cut can be made on the LS Settings
- 75 -
