Auto Update - One Click Programming for all Modules/Panels
u
Click the
green
button labelled
Auto Update Firmware
.
As soon as this is clicked, the system will automatically scan the console
and report the panels which need updating along with the required time to
update. Once this scan is finished proceeding with the update will allow
programming to take place, sending firmware to all panels that require it.
The progress screen will show the programming activity.
When the programming has completed, a screen will show how each of
the panels has been programmed.
u
Click
Exit
to close this screen.
Before the updated firmware will be used, the software must be restarted.
Please be aware that if there is a panel in the desk that cannot be
programmed for any reason, it may be possible for the update procedure
to stall, thereafter certain modules may remain in programming/boot
mode.
For example, on a channel strip, this will be indicated by the three leds at
the top of the channel strip remaining lit (CHM, DAW & FNC), and the ISO
and 8T leds at the bottom of the strip as well.
If this is the case, then you will need to program each module in the
desk individually using the following manual update procedure.
Manually updating individual Modules/Panels
(When the screen first opens, none of the options on the lower half of the
screen are visible, you need to click the button that says
Click To Show
Advanced Options
for them to be visible).
u
To manually update a panel, select the panel type in the
Select Panel
pull-down menu (and
ID
where relevant), and click
Program
.
u
If you try to program a panel and it fails to respond, you will be
warned that it is not possible to update the firmware on this particular
- 126 -
