Apex Classic Setup and Programming Guide v2.2
Page
86
b.
If you have changed the Administrator User Name and Password,
enter the current credentials (current user name can be viewed from
the Apex Display at System – Net Setup – Admin Login, current
password can be viewed from the Apex Display at System – Net
Setup – Admin Password).
NOTE: You can click the Show Password checkbox to
7.
Click the Update Firmware button to update the firmware
a.
You should see several update steps occur and when compete, you
should see “Operation Complete” in the log at the bottom of the
screen.
b.
Depending on network speeds, the process should take less than a
minute.
8.
After the firmware has been updated, the AquaController Apex will restart.
You can confirm the correct firmware has been installed by running a self
test from the Apex Display.
9.
Continue updating your system by updating the Web Interface using the
directions in the next section.
UPDATING THE APEX BASE MODULE WEB INTERFACE
Once the Apex Base Module Firmware is updated, the next step is to update the
Web Interface firmware.
Figure 14 - Apex Flash Utility Updating Web Pages
NOTE: Please allow the Apex Base module a few minutes to restart before
proceeding with updating the Web Interface firmware.
1.
From the Apex Flash Utility with the parameters filled out as in the previous
section, click the Update Web Pages button.
2.
You should see several update steps occur and when compete, you should
see “Operation Complete” in the log at the bottom of the screen.
