Apex Classic Setup and Programming Guide v2.2
Page
16
6.
Mailbox Username and Password – The credentials used to log in and
send mail (typically the same credentials are used to check mail). These
credentials are only required if your mail provider requires you to log in to
access the SMTP server (usually not required for ISP mailboxes while on the
ISP’s network).
NOTE: Setting these parameters up correctly is the first step in email alarm
setup. See the section titled Programming Alarms and Warnings in the
Programming Outlets section for information on programming the conditions that
trigger the alarm email to be sent.
Enable/disable the Email feature
Apex Display: System – Email Setup – Email: – push the Select button to
toggle this feature on and off.
Web Interface: Configuration – Network setup – click the Enabled or
Disabled radio button next to Email Enable, press the Update Network
Settings button to save changes.
SMTP Server name
Apex Display: System – Email Setup – SMTP server – use the up/down
arrows to change the highlighted digit, use the left/right arrows to select
the highlighted digit, when done, press OK.
Web Interface: Configuration – Network setup – click in the SMTP Server
field and type the appropriate server name, press the Update Network
Settings button to save changes.
SMTP Port number
Apex Display: System – Email Setup – SMTP port – use the up/down
arrows to change the port number, when done, press OK.
Web Interface: Configuration – Network setup – click in the SMTP port
(default 25) field and type the appropriate port number, press the Update
Network Settings button to save changes.
From Address
Apex Display: System – Email Setup – From address – use the up/down
arrows to change the highlighted digit, use the left/right arrows to select
the highlighted digit, when done, press OK.
Web Interface: Configuration – Network setup – click in the From Address
field and type the appropriate email address, press the Update Network
Settings button to save changes.
