Apex Classic Setup and Programming Guide v2.2
Page
19
User Name (only required if Email Authentication is enabled)
Apex Display: System – Email Setup – User name – use the up/down
arrows to change the highlighted digit, use the left/right arrows to select
the highlighted digit, when done, press OK.
Web Interface: Configuration – Network setup – click in the User name
field and type the appropriate user name, press the Update Network
Settings button to save changes.
User Password (only required if Email Authentication is enabled)
Apex Display: System – Email Setup – User password – use the up/down
arrows to change the highlighted digit, use the left/right arrows to select
the highlighted digit, when done, press OK.
Web Interface: Configuration – Network setup – click in the User
password field and type the appropriate user password, press the Update
Network Settings button to save changes.
NOTE: Use a password of 14 characters or less or authentication errors will occur.
SEND A TEST ALARM EMAIL
This function can be used to send a test email to verify end-to-end operation of
all components needed to send email alarms.
Apex Display: System – Email Setup – Email test: – push the Select
button to send a test message.
Web Interface: Configuration – Network setup – click the checkbox next
to Email test, press the Update Network Settings button to send a test
message.
EMAIL TROUBLESHOOTING
If emails are not working follow these steps to debug:
Telnet into the AquaController
In the start -> run box of your PC type “telnet 192.168.1.50” (replace
192.168.1.50 with the host name or IP address of your Apex Base
Module.
Login to the AquaController, using the controller’s login and password
(default login is ‘admin’, and the password is ‘1234’).
Once logged in via telnet you should see the “AquaController>” prompt each
time you press the enter key.
At the AquaController prompt type:
cons
1 maild
