Apex Classic Setup and Programming Guide v2.2
Page
50
from switches, the state of other outlets and more. To enable the Advanced
Programming mode, simply set the Program or Control Type to Advanced in the
Outlet Setup as described in the section titled Editing Outlet Programming. Once
an outlet is configured for Advanced Programming, you edit, add and delete
commands from the Apex Web Interface.
NOTE: When switching an outlet programmed with a Wizard (pump, temp, etc) to
advanced programming mode, the commands to perform the functions of the
Wizard will be automatically entered into the Advanced Programming area. This
can be a time saver when setting up an outlet for the first time.
To modify the Advanced program for an outlet:
Apex Display: Setup – Outlet Setup – Program Outlet – From this screen
you can:
Edit: use the up/down arrows to highlight and existing command you wish
to edit, push Select to enter Edit Mode. Use the up/down arrows to
change the command, push Select to move to the next parameter, use
the up/down arrows to change the parameter, repeat until all
parameters are set, push Save to save changes or Exit to discard
changes.
Delete: use the up/down arrows to highlight and existing command you
wish to delete, push the left/right arrows until the command displayed at
the top of the screen indicates Delete Statement, push Select to Delete
the command, push Save to save changes or Exit to discard changes.
Insert New Command Before the highlighted command: use the up/down
arrows to highlight and existing command near where you would like to
insert the new command, push the left/right arrows until the command
displayed at the top of the screen indicates Insert Before, push Select to
insert a new command before the highlighted command, use the
up/down arrows to select the command you wish to add, push Select to
move to the next parameter, use the up/down arrows to change the
parameter, repeat until all parameters are set, push Save to save
changes or Exit to discard changes.
Insert New Command After the highlighted command: use the up/down
arrows to highlight and existing command near where you would like to
insert the new command, push the left/right arrows until the command
displayed at the top of the screen indicates Insert After, push Select to
insert a new command after the highlighted command, use the up/down
arrows to select the command you wish to add, push Select to move to
the next parameter, use the up/down arrows to change the parameter,
repeat until all parameters are set, push Save to save changes or Exit to
discard changes.
