NEC S1400 NF1400-SR40E, Руководство пользователя

Страница: 42 / 161

4-1
4. Installation and Connection Procedures
This chapter describes the procedure for the installation and connection of the disk array unit. In
general, follow the procedure shown in Section 4.1 for the installation and connection of the disk array
unit.
Take care of the matters described in Chapter 1 "Notes on Installation and Handling of Disk Array
Unit" in doing the jobs.
CAUTION
 Do not give shock and vibration to the disk array unit. Excess shock or vibration
may cause the disk array unit to be defected.
 While the disk array unit can accept the power of 100 - 240 VAC (50/60 Hz), the
power cord coming with the disk array unit can only accept 100 VAC. Use 100
VAC (50/60 Hz) when the attached power cord is used. Using power of different
voltage may cause electric shock, smoke, and/or fire to occur.
4.1 Installation and Connection Procedures
 Check of components in package
Check the components in the package following "Check of Components in Package". If any
component is missed, contact your sales representative.
 Installation onto the rack
Install the disk array unit on the rack according to Appendix D "Installing Unit on Rack".
 Connection of host bus adapter
Connect the host bus adapter according to the manual provided with the host system or host
bus adapter. And, install the proper driver.
 Connection of FC cable
Use the cable compatible with the disk array unit.
Insert the connector until the latch emits a click.
Do not bend the cable forcibly.
When disconnecting the cable, be careful not to apply excessive force to it. Hold and remove
the connector pushing the latch.
 Connection of the Ethernet (LAN) cable
To prevent malfunction, use the Ethernet (LAN) cable of the shielded type.
Insert the connector until the latch emits a click.
Do not bend the cable forcibly.
When disconnecting the cable, be careful not to apply excessive force to it. Hold and remove
the connector pushing the latch.