NEC N8100-1223F, Руководство пользователя

Страница: 253 / 482

Installing and Using Utilities 6-5
Express Setup
"Express Setup" is intended for initial setup of the server. Its automatic installation mode guides
the user easily through the process by detailing specific hardware features and providing screen
prompts for software selection and configuration. The program loads the utilities and drivers,
applies RAID settings, partitions the disk, and installs the desired operating system.
If you install Windows Server 2003, after a few tasks are completed, all that remains to be done is to
remove the NEC EXPRESSBUILDER CD-ROM and install the Windows CD-ROM, input a
product ID number, and acknowledge the license agreement.
IMPORTANT:
„
The Express Setup is intended for the initial setup of the server
system and, therefore, the Express Setup clears the contents of the
hard disk.
„
When the setup is started, do not turn off the server until the setup
is completed, and also make sure not to remove the "Configuration
Diskette" from the floppy disk drive until the message that allow
you to remove it appeared.
Tools
"Tools" is also intended for initial setup of the server. It provides more installation options than
Express Setup and permits the user to quickly create utility support disks, run the Off-line
Maintenance Utility and system diagnostic utility, set up a maintenance partition, and update the
various BIOS programs.
Tools Menu
Save/Restore RAID Configuration Data
Off-line Maintenance Utility
System Diagnostics
Create Support Disk
Setup Maintenance Partition
BIOS/FW/etc. Update
RAID Board: Present
Total Drives: 1
Drives in Group: 1
Hot Spares: 1
RAID Level: 7
Write Mode: WRITE_THRU
Maint Part: Present
System Management
Help
Return to the Top Menu
„
Save/Restore RAID Configuration Data
The item allows the configuration information on the disk array system to be saved or
restored from the floppy disk.
– Save Disk Array Configuration Data
The configuration information on the disk array controller is saved into the
floppydisk. If you set or change RAID, always use this function to save the
configuration information into a floppy disk.