NEC N8100-1223F, Руководство пользователя

Страница: 373 / 482

Upgrading Your Server 9-11
When the hard disk drives are in the disk array configuration, you can restore the state before an
error using the auto-rebuild feature that stores the data in the old hard disk drive into a new one.
The auto-rebuild feature may be enabled or disabled depending on the RAID level.
Auto-rebuild is automatically carried out when you hot-swap a failed hard disk drive with a new one
(replace the disk while the server is powered). While auto-rebuild is in progress, the DISK lamp
flashes green and amber alternatively to indicate it.
IMPORTANT:
When auto-rebuild fails, the DISK lamp lights in
amber. Remove and install the hard disk drive again to restart auto-
rebuild. (If the disk array monitoring utility is installed, check the status
through MegaRAID Storage Manager.)
Observe the following notes for auto-rebuild.
„
Do not power off the server in the period between a hard disk drive error and completion
of auto-rebuild.
„
When you removed a hard disk drive, wait at least 60 seconds before installing the hard
disk drive back again.
„
Do not replace another hard disk drive while rebuilding is in progress. (The DISK lamp
flashes in green and amber alternatively while rebuilding the hard disk drive.)
DISK lamps