Maintenance 7-11
RELOCATING/STORING THE SERVER
Follow the procedure below to relocate or store the server:
CAUTION
Observe the following instructions to use the server safely. Failure to follow
these instructions may cause a fire, personal injury, or property damage. See
pages 1-3 to 1-8 for details.
■
Never attempt to lift the server only by yourself.
■
Do not install the server in any place other than specified.
■
Do not connect/disconnect any interface cable with the power cord of the
server plugged to a power source.
IMPORTANT:
If the server needs to be relocated/stored due to a change in the floor
layout to a great extent, contact the service representative.
Make sure to make a backup copy of your valuable data in the hard
disk, if any.
Make sure not to apply a shock to hard disks to relocated the server
if the contains any.
It is recommended that the server and the internal devices should be
stored in a place where the room temperature can be maintained. It
is important for the server or internal devices to work normally after
storage. Store the device in the place where temperature ranges
between -10 to 55ºC and humidity ranges between 20 to 80%,
without dew condensation.
If you use the server after transported or relocated, check the system
timer and adjust it if necessary. If the system timer advances or
delays remarkably with the passage of time, contact your service
representative to repair it. The server or internal option device may
be dewed if it is brought to a warm place from a cold place suddenly.
Using a server or an internal device with dew attached may cause
malfunction or failure. Make sure to adapt them to the operating
environment before using them.
1.
Take a floppy disk and a CD-ROM out of the server, if any.
2.
Power off the server (the POWER lamp goes off).
3.
Unplug the power cord of the server from a power outlet.
4.
Remove all the cables from the server.
5.
Hold the server by its bottom with at least four persons to carry the server.
6.
Protect the server with the shock-absorbing materials, and pack it securely.
Содержание N8100-1223F
