NEC N8100-1223F, Руководство пользователя

Страница: 367 / 482

Upgrading Your Server 9-5
DEVICE INSTALLATION OR REMOVAL PROCEDURE
Install or remove a component from the server in the following procedure.
3.5-inch Hard Disk Drive
The 3.5-inch device bay on the front of the server contains five slots on which hard disk drives can
be installed. The device bay is not equipped with any hard disk drives (excluding when one or
more built-in hard disk drives are ordered). Purchase the hard disk drives additionally if required.
IMPORTANT:
„
Do not use any hard disk drives that are not authorized by NEC.
Installing a third-party's hard disk drive may cause a failure of the
server as well as the hard disk drive. Purchase hard disk drives of
the following models:
– N8150-199 (36.3GB, 15,000rpm, SAS)
– N8150-200 (73.2GB, 15,000rpm, SAS)
– N8150-201 (146.5GB, 15,000rpm, SAS)
„
The supported RAID level depends on the disk array controller to be
used.
– Onboard RAID:
RAID0, RAID1, and RAID5 (See "Disk Array Configuration" in
this chapter.)
– Optional disk array controller:
Refer to the manual that comes with the disk array controller. (If
you purchased the board by BTO (built-to-order), the manual is
provided with the server.)