4. Setup for Solving Problems
Express5800/R320c-E4, R320c-M4, R320d-E4, R320d-M4 Installation Guide (Windows Server 2008)
104
Chapter 1 Installing OS
11. In the
Paging file size for each drive
group box, specify as follows:
For the
Initial size
text box, specify a value equal to or greater than the
Recommended
value shown in
the
Total paging file size for all drives
area.
For the
Maximum size
text box, specify a value equal to or greater than the value specified in the
Initial
size
text box.
After specifying the above values, click
Set
.
Note the following when specifying a paging file size.
–
The above paging file sizes are recommended for collecting debug information (dump file). The initial
size of the Windows partition paging file must be large enough to store dump files. Make sure to set a
sufficient paging file size. If the paging file size is insufficient, correct debug information might not be
able to be collected due to a shortage of virtual memory.
–
For details about the Recommended value in the Total paging file size for all drives area, see
System
partition size
in
Chapter 1 (Before Starting Setup)
.
–
When memory is added, re-specify the paging file according to the increased memory size.
12. Click
OK
.
A message to restart the system might appear, depending on the modifications made.
In this case, restart the system.
Specification of the memory dump settings is now complete.
