Falcon II Outdoor series printers – Maintenance Manual
326
AP-74065, Rev. 1.0, 21/11/03
9.3.5. Problems relating to the paper cutting operation
No. Phenomenon
Check point
Action
Refer to
(1) Check the
operation panel and
make sure that the
media cutting
setting is not set to
off or manual.
• Change the
setting.
→
User’s Guide
(2) Check the
operation panel and
make sure that
PaperDet. has not
been set to
TakeUpRoll.
• Change the
setting.
→
User’s Guide
(3) Check the cutter
grooves for
accumulated paper
dust and clips.
• Remove the
accumulated paper
dust along the
direction of the
grooves.
→
User’s Guide
(4) Is the cutter cap
securely insalled?
• Reset the cutter
cap securely.
→
User’s Guide
(5) Check the
cutter’s up and
down sliding
operation.
• If it does not rise :
go to step 4
• if it rises : go to
step 5
-
(6) Check if the
cutter drops to the
bottom end under its
own weight when
the cutter is installed
without the cutter
spring.
• If it drops :
The cutter spring
may have a
problem. Replace
the cutter spring
while referring to the
unfolded view.
• If it does not drop :
The cutter may have
a problem. Replace
the cutter. If the
cutter does not drop
after it is replaced,
replace the cutter
holder.
→
Replacing the
cutter holder, cutter
spring, cutter cap,
solenoid assembly
and solenoid spring.
1
The cutting operation is not
performing correctly.
(7) Check the up
and down operation
of the solenoid via
“Life/Cutter” of the
self-diagnostic
function.
