Falcon II Outdoor series printers – Maintenance Manual
100
AP-74065, Rev. 1.0, 21/11/03
4.6.7. Replacing the steel bearer, tube guide, CR tape power cable and ink tube
Notes :
¾
To replace the board and connect or disconnect the FFC type cable, you should
leave the plug disconnected from the power socket for a while. Otherwise, over-
current could be generated and damage board.
¾
Remove following covers before replacing the steel bearer, tube guide, CR tape
power cable, and ink tube.
Side cover R: refer to "Removing side cover R"
Side cover L: refer to "Removing side cover L"
Front cover: refer to "Removing the front cover"
Carriage cover: refer to "Removing the carriage cover"
Y rail cover: refer to "Removing the Y rail cover"
Step 1 :
Remove the 8 screws fixing the CR cover.
1 = CR cover
2 = Screws (M3x8) fixing the CR cover
Step 2 :
Remove the CR tape power cable connector from the CR board assembly and Mainboard assembly.
Step 3 :
Remove the 2 screws fixing cable push plate.
